Barcode Scanner

The EBMS software is capatible with a variety of barcode scanners.   The following pre-programmed scanners are recommended:

• Zebra DS2278 Bluetooth POS scanner:  See instructions below.
• Honeywell POS scanner:  See instructions below.
• MyEBMS scanners:  Review [Inventory] MyInventory and Scanner > Scanner Hardware to setup instructions.  
• Other scanner setup:  Review [Inventory] Barcodes > Programming Scanners and Barcodes for general scanner programming.

Zebra DS2278 Bluetooth Scanner

1. Plug the cradle into the computer

2. Place the scanner into the cradle for at least 15 minutes (Make sure the scanner is charged)

3. Remove the scanner from the cradle and scan the following QR code:
   

4. Replace the scanner in the cradle and wait 1 minute

5. After 1 minute, test by scanning a barcode that you know is in EBMS

Review [Inventory] Barcodes > Scanning Barcodes for more barcode information within EBMS.

Honeywell Scanner

1. This scanner will have been configured before shipped to you

2. Plug the scanner in and wait at least 5 minutes for Windows to find the necessary drivers

3. Test by scanning a barcode that you know is in EBMS.

Review [Inventory] Barcodes > Scanning Barcodes for more barcode information within EBMS.