After the scanner is configured plug in the battery pack and the scanner will connect to the remote station with which it is associated. The scanner will give the user various prompts which will be covered in the following sections. For a list of possible error messages review the Scanner Messages section.
Login:
Prompt: Scan Employee ID
Scan or type in an employee ID. The employee ID’s are found by going to EBMS>Payroll>Employees. If the ID is valid the scanner will beep once and the prompt will change. If the employee ID is invalid, the scanner will make an error sound. If the EBMS Timecard module is used by the company, the timecard login can be used as well.
Select a Mode
Prompt: SELECT A MODE
This is the menu which allows the user to select the mode to work in. The modes are as follows:
Shipping
Receiving
Point of Sale
Inventory
Whse Transfer (Warehouse Transfer)
Select a mode to continue by scrolling with the up and down arrows, and pressing Enter to select. The other option is to select the mode by pressing the corresponding number (1 for the first item in the list, 2 for the second, etc).